J2 Fabrication now has a preorder up for the new GT500 crank support. I am thinking about ordering one for my 2013. It is probably overkill at this time as I only have a Gen3 VMP but I may upgrade in the future as blower tech. advances and it sure cant hurt. Any input?
Thanks Jay. I got what I was hoping for. Mods are close to yours: VMP gen 3, 10% lower/2.4 upper, DD149, ID 1300, Fore fuel system, Kooks headers/O/R h pipe, MPR's comp. cams.
Sorry to hear! Glad you and your family are OK. That's the important think. Like everyone is saying there are more than a few very nice GT500 out there for sale. Hope insurance treats you right.
Are you guys telling me I'm going to have to pull my sleeved block out and put the spray liner block back in order to have a 13 GT500 again. I mean i did loose 4 cubic inches but sh__, I didn't know I changed the hole car!
Brand new Vmp throttle body. Fits GT500/GT 05-14. Only opened box to verify correct parts. Going nomoblade is the reason for sale. My loss your gain! Thanks guys! SOLD
Ok thanks for sharing. Just curious as I have a lot of n2o parts not being used at the moment! Call me crazy be it would be cost effective, if there is such a thing with this hobby.
.
Unless you have racing goals, or are just plain crazy :), the torque from a 5.8/TVS2650 is more than enough for any street car. Rolling into the car at 3500-4000rpm from a 3rd gear highway roll is violent—and crazy good fun!
Congrats J! Bad ass times. Your car looks and runs great. I...
What a shame. They are great looking wheels. I had already sent my factory wheels to be widened when I saw these. Looks like I got lucky. Good luck with yours and thanks for posting!