Recent content by mcham

My 96 Cobra is in deep of a repaint real bad. She has a case of my clear is peeling and now I'm faded. I was looking into the plastic dipped option. What are the pros and cons of going this route? Also could someone post some pics of some plastic dipped SN95s Thanks

I have a 96 Cobra with about 130k on it, the motor still runs good. I wanting to do a rebuild that's not going to break the bank. This is going to be the 1st mod motor I ever did, so I'm kinda lost. I want to put a nice set of cams in the engine, maybe go .020 over, and a good oil pump. I'm not...

My ABS light came on the other day. How do you check to see what's going on?

What's a good thermostat to use in a 96 Cobra?

Up for sale is an 1996 Mustang Cobra #401, black with black leather interior, sitting on 20x9 &20x10 bullet wheels on new front tires. Power windows, seats, trunk, and locks. Kenwood Excelon CD with Blue tooth & I pod/phone ready. JL Audio Amps, 10W3 subs, XR 5x7 Components speaker, and Alpine...

Does anybody make sparkplug wire cover for 96-98 Cobras?

What's the best handheld tuner for a 96 Cobra?

How hard is it to install a starter on a 96 Cobra with BBK long tubes.

My Cobra is having some type of starting issues. When I try to start the car, some times when I turn the key it will not say nothing. All the warning lights come on. Then I push start the car it cranks right up (always happens in public, that's why I push start). Then a few weeks go by, and it...

I'm putting my Blk 96 Cobra in the paint shop the 1st week of June,:dancenana: 2 get a fresh coat of blk 4 Mustang Week. Here's the ? 2 leave the wing on or take it off? What do ya'll guys think I should do? Thanks for all feed back.

Who has the best deal on crossed drilled brake rotors out there?

My clutch quadrant shaft snapped in half today, on the end were the quadrant is at. Luckly I was home when it broke. I've been having clutch cable issue with the car (like a clutch pedal that is hard as a brick). My question is do I have to replace the whole pedal assembly or I can just buy the...

In my 96 Cobra my clutch pedal is harder than a brick. Don't know if that old UPR cable has stretched or is binding. What's a good cable to go with? Also where to get it from? Just put a new clutch in the car, and replaced everything but the cable. Thanks:beer:

I was on I-20 the other day and all of a sudden my speedo went from 80 back to 0. Got home and everything is hooked up on the trans. What should I check next? Thanks for the help. By the way my car is a 96 Cobra

I'm ready to change up the catback setup on my 96 Cobra. My car has the BBK long tubes and H-pipe on it with a set of Flows. Any ideas on a good sounding cat back I can try. Thanks for the help