IMG-0210 by ricekilla04, on Flickr
I have a set of 72lb Bosch injectors that have been flow tested and cleaned. I’m going a different route with my setup. $300 shipped
Thanks everyone, after careful debate I decided to go with a ported trinity blower and supporting mods. More power and upgrades for the the cost of the cams installed.
I have a 07 with 2.5 upper, JLT 123mm, VMP 67mm TB, MRT off-road h pipe, Ford Racing touring axle backs, and Shelby heat exchanger with dual fans. I don’t race and this is more of a family cruiser/ show car. I’ve been looking at doing a set of custom grind cams for that lopey idle and some hp...