For anyone who buys a used Kenne Bell for a 96-98 Cobra, here is a list of the vacuum hoses that are needed:
Vacuum hoses
7/32” x 18” to old evap hose
7/32” x 14” to splitter
7/32” x 9” to vacuum line assembly
5/32” x 9”
5/8” x 8 ¾“ to IAC adapter
½” inside diameter x 20.5”...
Quick update on where I'm at.
So I picked up a used KB.
Below is everything I've put together to go on the car.
MAF - Pro M80
CAI - Anderson Powerpipe
Injectors - 48lb
Fuel pump - Aeromotive #11542 - 340LPH
Adjustable Fuel Pressure Regulator - Aeromotive #13102
Fuel Pressure Gauge -...
The 03/04 Cobra is also 90mm, but if the IAT will cause issues, then i will just get a lightning MAF.
I will join SN95 Forums and have a look for this thread, thank you!
Thanks Lzr96Snake
Any chance you have some pics of your set up?
Specifically the IAT sensor and the throttle cable?
I don't see any options to send a PM, I could send you my email address.
I also see in your sig that you're running a 80mm MAF, is this correct?
Thanks everyone for your help.
I think I need to phone KB and see if I can remove the BAP and chip from the package and I will get the car on a dyno for tuning.
I like the idea of upgrading the fuel pump and injectors.
For the fuel pump, I was looking at the Quantum 340LPH.
42lb injectors sounds...
I am mulling over the idea of installing a Kenne Bell on my 97 Cobra.
This is a weekend street cruiser that never sees any track.
Yes, I understand that there is probably better power to be had with a centrifugal or turbo, but this is not the route I want to go.
My questions for those that...
Hello all. New member with a 1997 rio red cobra.
Full suspension is done:
Steeda full length welded SFC's
Bilstein shocks and struts
Roush springs
MM CC plates
MM rear adjustable LCA's
Steeda double adjustable UCA's
Exhust is done:
Ceramic longtube headers
Catted H Pipe
Pypes M80 mufflers...