Recent content by Roushman

All in all I was please that my tune and DR produced 2 of my 3 runs 150....mph... First one was just a feeler. Lost grove and let out at third. By the way. HellKitty ran 143

Finally switch to NT05's 315 35 20 Took about less then 1 mile to realize the stock tires really did suck. I can't wait to try them in Ocala this weekend. If you are on the fence. Have no fears. Switch now

Some minor scuff marks popped up on the middle section around the shifter on plastic. Anyone have a solution to fix minor scuffs or wear on this piece.

With a tune and TB only is it necessary to change plugs or can I wait

So I ordered the stage 1 pack and added the TB with a tune. I figured I would keep it mild. No base Dyno but I would like to 660rwhp. What's everyone's guess or does anyone have this set up?

Had these put on. Thought it was nice touch to front

So tomorrow should be the big delivery. After owning an 03 roush and then 03 cobra it's time to try the 14 Shelby. I have the 821a package with track pack, nav touchscreen , shaker audio, and some other goodies. It's the ruby red black stripe coupe. No mods planned. Staying stock after all the...

Couple weekends ago. I am listed as silversnake Florida Streets Vid 01 - HOLESHOT-PRODUCTIONS! - MAFIA MOTORSPORTS RACING.....THE "ANTI-RICE".....

Last couple of days my whipple started making this weird murrmur noise. It starts at idle through all rpm range and gears. No boost loss. Best I can say about noise is like turning a electric motor< rc car> by hand. Its the Gen 1 with plenty of miles. Any guesses.....:shrug: Link to listen...

Ahh you win some yea lose some:shrug: All cars over 600rwhp++ AKA: Silversnake 2003 whipple cobras and spray'd cobra - Video

enjoy Me<AKA SilverSnake>> Mofo Production- TT C6 Corvette vs GT35R 240sx 200 - Video

RX8 hp unknown, Driver IQ unknown Tried to roll up on me at a light with his girl I guess to show off. Put about 4 corn fields on him by 3rd and shut down. He never came up on me again though I slowed to 40mph in a 50:shrug:

Steg 3 ported Eaton with pulley and inlet not ported. 600.00 like to do local made 501 and 537 on stock inj. Pics farther down in thread

Ok it's been along time coming and the end is in sight. I can't wait So what will I make on the mustang dyno: MODS:2.3 whipple 23lbs< I think> GT500 pumps, all supporting MODS, magnaflow cb,prochamber and a built shortblock Let the guessing begin