I have bbk long tubes right now and I’m waiting on my Rossler th400 to get to perform the swap. I am pretty sure these bbk’s aren’t going to clear the th400. What off the shelf if any will clear the th400 in the 03 cobra?
Thanks
Yea but then you may as well go push rod motor and be tons easier to work on. I think I’m gonna buy me a different car to play with and leave this one like it is. I hate to ruin such a nice cobra.
Yea turbo would be the way to go but it’s not a terminator anymore imo when you go that route. I’m gonna run the blower as long as I can. What type of compression would you run.
Can it be done? I currently have a KB2.8H with Behemoth inlet cams E85 all supported mods ect. Long block is stock other than cams. I want the car to run high 5’s 1/8th mile. What’s it gonna take and can it be done with this blower.
I run it on pump gas around town but I do have a e85 and c16 tune. Gonna put the e85 tune in it. Just got a drum of e85. I bought the car a few months ago it has a Dyno sheet from Kurgan it made 680 on pump and right at 800 on e85.
Yea I like the kB look better plus it’s not cast. Looks like a more expensive piece to me. But it don’t matter what they look like if they put down the numbers
Torch red 04 with 42k miles. KB2.8H behemoth inlet proline cams Kurgan triple 340l return fuel system. Viper spec t56 8.8 rear nice as they come 680whp on 93, 724 on e85 and 780 on c16. It would take 28k to buy it tho.
I was really leaning towards this until Liberty told me 10 weeks once they received my tranny. Anyway does anyone on here have this done to a cobra? Sounds like a lot of fun to me. But with the wait looks like it will be auto swap for me.
Another thing I like about the the terminator is the looks. Plus it’s not a 4100# tank like the new cars. The 05 and up cars just don’t do for me. Terminator is by far the best looking mustang IMO.