Search results

07 mustang white with tan leather interior. pony package, shaker stereo, all power, bullet wheels, auto. 24k miles. one owner no smoker. my wifes car need to sell. baby comming need 4 doors. 15k flexible a little i owe more than 15 already.

whats it worth? am in the middle of building the motor in my 03 and was going to put fresh paint on while the motor is being built. car is silver has the usual bolt ons, spec clutch, strait axle etc. motor will be 20 over with cp pistons. so what could i get for it fixed? also anyone out there...

don't need trunk lid dont care about color. just needs to b in good shape.

i need a stock 03 cobra lower pulley setup.

does anyone make a lower pulley in odd sizes like 3lbs?

my black 03 has some nasty looking swirls and scratches and no longer shines. after some reading in this forum i am thinking of this: SSR 2.5 SSR 2 SSR 1 to get rid of the swirls EX-P to seal Nattys Blue Past Wax Does this sound good? Are the stepps in the right order? Remove...

does any one know what would cause my car to throw a p1000 code? it is a obdII system check incomplete code. also are denso it22's a colder are hotter range plug than denso it24's? trying to figure out a skipping problem on cold start ups. the higher the number the colder the plug found...

not sure what is wrong..mods in sig with custom predator tune. car ran fine with the new tune for a bit but now does not and getting worse. car skipps bad when cold and will barly drive until it gets warm. dies some times at idle hot or cold. sometimes rather than dying it starts idiling like...

stuck in closed loop and timing too high my 03 is stuck in closed loop mode and the spark timing advance jumps up to 52 degrees under hard throttle. so ays the predator. no codes are present. what is the problem? could the mass air be pegged out?

just installed my kooks long tubes and kooks offroad x-pipe. With my flowmaster 2 chamber mufflers this setup sounds very mean, but WAY TOO LOUD. Do any of you have this setup or one similiar with more quiet mufflers? any help or suggestions? going to stay with these headers and x-pipe but i...

does anyone have a used stock gasket off of an 03 or 04 car that they are not going to use? i am trying to make a set of header flanges.

going with a stick axle in my 03..sould i go with 3.73 gears or stick with 3.55's..give me your thoughts or expirences..thanks

who has the best port job for my cobra's eaton? i am going to do a port but not sure who to go with....opinions, experience, dyno numbers any help would be great.....

does anyone know who make a piggy back system for the computer so i can put a electronic automatic in my 03?

what size are the stock udlers on 03?

olny picked up 2 tenths and 3 miles per hour going from stock to 2.76 pulley with a metco 100mm and a predator with a custom tune. this seems a bit low. with poor traction 2.2 60' car ran 12.94 at 112mph in about 95 deg. heat with about 90% hum. car is stock except for pulley...aany help/advise

what is the max hp levels that the 03 returnless fuel system can safely provide fuel for...

i went to my local track in montgomery, al last night. the temp. was around 90-95 and the humidity was about 95-100 it rained at the track and we had to wait about an hour for them to dry the track. i had a real hard time getting the car off the line with out bogging or spinning the car. car...

just got my 03 cobra...what are the best mods to go with first??what kind of hspwr will i get??what have you guys hade the best luck with?? thanks