Search results

*SOLD* Originally purchased this kit for an earlier 4V with B heads which didn't work out. Designed to work on 03-04 4V heads. May also work on 99-01... not sure. Kit is complete from Cobra Engineering. Was only removed from the box to test fit. - Included is (2) head fittings w/hardware...

What about swapping to the 94-95 spindles? That should pull them further in.

Updated with pricing.

These are 18X8 fronts and 18X9 rears. Pretty rare for this specific wheel to come staggered from the research I've done on them. They are definitely not perfect. There is some rash on 2 of them as can be seen in the photos but honestly for their age I'd say they're in fair condition. Fits...

Bump

Rear bumper cover from a 2004 Mustang Cobra in oxford white. The vehicle was involved in an accident and there is damage to the bumper as can be seen in the photos. I'm not sure what all would be involved in repairing it hence the low asking price. It has the puncture hole on the side and a...

Just noticed this while in the process of changing out my carpet. This is right behind the fuse box under the dash. Should this be disconnected?

Just got around to messing with it again. Guess it was the battery. Replaced with a new motorcraft one and problem is gone. Much appreciated.

Looking for insight on what's going on with my alarm. Everything works as it should as long as I use my key fob to lock/unlock. However, if I use the key itself to unlock the door it sets off the alarm. Anything I can reset to fix this? Car is a 97 Cobra. Thanks!

Finally got my tires mounted. Just waiting on suspension now.

Also swapped out the coils for new motorcraft ones. Any ideas on what could be my underlying issue?

Anyone else had issues with Ford Racing plug wires? Ordered a set to replace the stock ones on my 97 Cobra and car began misfiring on the initial drive after installing. Swapped them back to the original wires, issue is gone. Returned that set of wires for a new set of FR wires, same exact...

PM'd

TTT

Looking for the hose and silencer that runs from the IAC to the intake tube. Thanks!

Messaged you.

Sounds good! Appreciate the help.

Thanks Deceptive. Looked through your build thread and I'll mostly likely be doing the full dark charcoal swap as well. Have you come up with a solution yet for rewiring the rear defrost button to the new location?

Thanks for the info. I would most likely go with an aftermarket double din. I guess my real question though is will a complete 01 dash + dash harness swap into my 97 without splicing harnesses?

Looking to swap out the interior in my 97 Cobra from the factory Saddle to either black or dark charcoal. I figured since I'll have to swap the entire dash anyways would it be possible to just swap in an '01 up dash to take advantage of the double din? I know it will fit but just curious to know...

Sold

I really hate to part with this one. It's a pretty rare car and I've had alot of fun with it over the last couple of years. I purchased this vehicle from John Thornton Chevrolet in March '09 with 8500 miles on it. It now has 64,500. It was my daily driver for a while but I now have a work...

I bought this Bilstein set from Maximum Motosports on October 3rd. They were installed on the car, driven down the road once and then immediately removed due to them being a bit too stiff for my drag setup. They cost me over $630 not including labor. Asking $550 shipped.