Not really sure where to put this, just looking for ideas of what areas to check.
basically I have an `03 IRS in my car, and it's hard to tell where the sound is coming from but now on the freeway when making a slight right turn, and when pulling into my driveway very slowly, I can hear/feel a...
Mine is near mint, and should clean up very well if that is something you desire.
I'm in Socal, so there's no rust issues, but I have dragged the mufflers while going over speed bumps a few times, so they are not perfect. They've only been on my car for 6k miles, it's a daily driver.
In...
Have installed an IRS in my `97, I tried to get away with just bending the stock brake hoses out of the way, however after a track day I developed a small leak from crushing the brake fitting with an upper control arm.
I ordered the MM IRS SS braided brake hoses, however they are...
86-10 Mustang 8.8" 4.30 Ratio Rear Axle Gear Kit by Ford Racing at LRS - Same Day Shipping!
I was told I may require different bearing set with my IRS, but I already received this kit when I purchased the IRS (not installed in it).
the ford racing catalog lists 4209 a/b/b1/c 8.8" install...
My day job is an IT Systems Administrator, and we have some parts laying around that I want to clean out of my workshop.
All Dell branded, or removed from Dell Precision 390 and T3400 workstations when they were upgraded. Core2Quad Q6600 based PC's.
512mb DDR2 667mhz ram
$15...
both doors, no speakers, no door lock actuators, no window motors, just glass and door skins.
door panels, some scratches/nicks, but overall real nice, door cups are in them but the clips are all busted by PO, door handle bezels I have 1 grey (passenger) to match these, and the drivers I have...
removed from 1995 mustang GT
headunit/cd player show wear, I didn't test, I just pulled everything.
front amp
2 x rear amps
door speakers + tweaters + "mach460" pods/mirror covers
rear speakers/sub box setup
single din tape deck headunit
single din cd player
I can possibly get the...
Removed from 145k mile 1997 GT which had PI heads/cams/intake.
Has a spun rod bearing.
Includes:
8 pistons
8 rods
rod end caps
crank
block
waterpump
oil pump (should be replaced)
one of the pistons/rods has been removed for inspection, and yes, that rod had a spun rod bearing.
Parts not...
I have a `97 GT that I am converting into a 4valve, I have a complete `94 lincoln mark viii w/ 80k miles that I just picked up for the motor.
I have a friend with a `96 cobra motor + ecu + engine harness.
I am looking to buy everything from him that I will need.
I would like to avoid...