Search results

Brand new still in packaging... selling my cobra so selling the part. Billetflow IRS Brackets

$150 and shipping... PM me

Brand new still in packing . I bought direct from Billetflow. Selling car so selling the part. $100 PM me...

Rare Color 03 Sonic Blue Convertable SVT Cobra close to 500RWHP and lots of torque. The driveline is beefed up for 800+ rwhp with a Viper spec T-56, Cryodipped hardened half shafts. Pro-M 92mm MAF Steeda Tri-Ax for T-56 Viper spec T-56 w/ 26 spline input 31 output with yoke Spec Stage 3 Clutch...

Rare Color 03 Sonic Blue Convertable SVT Cobra close to 500RWHP and lots of torque. The driveline is beefed up for 800+ rwhp with a Viper spec T-56, Cryodipped hardened half shafts. Pro-M 92mm MAF Steeda Tri-Ax for T-56 Viper spec T-56 w/ 26 spline input 31 output with yoke Spec Stage 3 Clutch...

Perfect condition... 4k miles on engine. Has all performance/engine modifications completed short of Blower/fuel injectors. I'll try to list everything it has but will probably forget some. I've done everyything I can to prep this truck for a KB/Whipple/Steg upgraded blower. It's up to the new...

FS: 2002 Lightning, built engine 11.7@124 (Upstate New York) moderator... please delete this thread in leiu of changed new thread. Thank you.

I was interested in knowing what the usual requirements are for pacing. I read somewhere that it requires some fundamental training and experience to hold up in court as well as a sufficient time frame during the pacing process itself. for example: let's say I tail a guy for a few miles and...

Many of you know that I am running a lot of boost and have had some trouble with air flow. My previous setup included a Lightning CAI and the stock 90mm MAF. I've been pegging 5 volts from the mass air flow sensor and thus getting some pinging/detonation on cooler days. Today my new Pro-M 92mm...

Has anyone put on HRE547R's or HRE847R's (same rim less bolts) ? AND Has anyone tried a 19" rim ? Will it even fit the cobra ? I think I have narrowed my search down to the new CCW HRE replica ... they are stronger, cheaper and lighter than HRE's and look a little better even...

ok ok... what's the deal here ? Do you use the yellow stuff or orange stuff ? What's the difference between them ? or can I just use distilled water and some water wetter in the warm months ? and will that help run coller ?

Well, I figured I finally cured my pulley slip problem as much as possible at this point so I dyno'd today. I tried a few reccomended tunes but could only make what you see below. Given my mods I was hoping for a bit more. I'm going to try adding some more timing to the last program I dyno'd...

I'm looking for a good website that actually has pictures of all the reflective bumper inserts they sell. Anyone know of such a site ?

How much rubber can I fit on 17x11 inch Boyd Coddingtons ? http://www.billetwheel.com/Wheels/Signature/timeless2.html and how fat can we go before clearance problems ? 305 ? 315 ? 335 ? 345 ?

Reichard Racing pulley tested @ Excessive Motorsports East Hey folks... I posted this over in the Lightning forums... it has some interest to 03 Cobra owners too (Lighting size upper pulley)...see below: Excessive Motorsports East recently tested this new upper pulley on an 03 Cobra. It...

Anyone have reccomendations for a front plate frame that doesn't bolt on ?:shrug: