Has anyone else installed the crower stage 3 blower cams or any hi lift after market cams?
If so what changes had to be made in order to compensate for the cams as far as the tune is concerned?
i installed mine and the car seems to be running very rich,I hooked an OBD scanner to it and cleared the existing codes then downloaded codes again and the only thing it shows is MISFIRE.
Should it be neccsary to put the car on the dyno and completely rebuild my tune from scratch to accomodate these cams?
Any input greatly needed and appreciated.
Was i wrong in assuming that the factory EEC could compensate to some degree to accomodate these cams until the engine and clutch are broken in before attempting to spin the dyno??
If so what changes had to be made in order to compensate for the cams as far as the tune is concerned?
i installed mine and the car seems to be running very rich,I hooked an OBD scanner to it and cleared the existing codes then downloaded codes again and the only thing it shows is MISFIRE.
Should it be neccsary to put the car on the dyno and completely rebuild my tune from scratch to accomodate these cams?
Any input greatly needed and appreciated.
Was i wrong in assuming that the factory EEC could compensate to some degree to accomodate these cams until the engine and clutch are broken in before attempting to spin the dyno??
Last edited: