has any one ran a 10sec et with a apten,2.76 upper, 6 lblower,nitrous
10sec possible w/ported apten,nos
- Thread starter tonythetiger
- Start date
people have run it with less
whats your best run hj16
not a 10.XX Ill tell you that
I know a guy who went 10.7 with 2.93 and 175 shot with solid axle and a very conservative tune.
F8L BITE has run a 10.97 on STOCK EATON, STOCK IRS and no juice. I believe his setup is a 6lb lower and 2.8 upper. He was on drag radials, I believe. Check out his signature in any of his posts. :thumbsup:
***EDIT*** I am cutting and pasting his signature here:
Last edited:
Definately possible. But, you're gonna have to find a well prepped track to do it at.
if i remember correctly i think all you would need would be cai, exhaust, DRs,apten, 2.8 or smaller, 50 shot, and nice tune. Ive seen a couple people around here with this setup and hitting 10.9x. . . ill let them post the hard facts though, im going from memory.
:rockon:
:rockon:
yes u can
there was a guy at nmra at bowling green that ran 10.7x
there was a guy at nmra at bowling green that ran 10.7x
You guys are forgetting one thing that you absolutely need...
A GREAT driver.
To hit a 10, you need a great launch, good shifts at the right shift points, a well prepped track, and everything working right for the run.
A GREAT driver.
To hit a 10, you need a great launch, good shifts at the right shift points, a well prepped track, and everything working right for the run.
I thought that kind of went without saying? :??:
All I know is that I can't do it......... Yet! :thumbsup:
Practice makes perfect.
lol , thanx jay!!!
i have apten , 2.75 RR pulley, magnaflow catback , mac prochamber , steeda cai, and efi flash by MUSTANG MAGIC and a 30 shot. i ran 11.06 @ 125.89 on motor 1.61 60' and 10.99 @ 128.49 on a 30 shot 1.69 60' in 88 degrre heat and 78 % humidity. car will go 10.80s @ 130 as is. but like everyone said , you have to know how to drive . here is the in car shot of my 10.99 pass. enjoy!!
http://www.03cobra.net/newven.wmv
ive gone 10.98 with an unported eaton with just a 2.8 and the basic bolt ons plus a built solid axle
1.63, 6.92@97, 10.98@122
i dont remember the 330, i keep all my slips in my car and i just got done playin basketball so im too tired to go get em haha
stock clutch, 28x10.5s
next mods: cage, 26 spline input shaft, spec stage 4, and THE JUG!(100 shot):rockon: lookin for some .40s
i dont remember the 330, i keep all my slips in my car and i just got done playin basketball so im too tired to go get em haha
stock clutch, 28x10.5s
next mods: cage, 26 spline input shaft, spec stage 4, and THE JUG!(100 shot):rockon: lookin for some .40s
Last edited:
Users who are viewing this thread
