from what i have searched and found out i know that with any 15 wheel you have to grind on the tie rod and depending on width and backspace depends how much you have to grind and if you need low profile brake banjo bolt like from mm. i just ordered some 15x10 w 6.5bs weld rts with black centers so i will be taking on this challenge in a week or two. do some searching on here their was a tread from someone with good pictures of what he did to get some 15x10 wheels to fit. what wheel were you looking to get?
Like he said, bust out the grinder and if you are skiddish its not a task for you. You can either grind the banjo bolt down or get the low profile one, and you have to take quite a bit off the lower part. On and off 100 times till you dont rub anymore.
I'm planning on going with the weld rts with black centers also. I don't mind a little grinding. Thanks for the info and I'll look for the other thread.