I was up at my pops house this last weekend and decided I wanted to put the cobra in storage at his house and break out my very first mustang that I got when I was 17 that's been sitting a few years. It hasn't had insurance on it in about 3 years since I joined the Air Force so I decided it was time to stop putting mileage on the terminator and show my fox some love by putting my iForged on it and slap a new motor setup in it. When I got the car it was a roller and my dad and I built the engine along with a few other things. Long story short a vortech 351w that came out of my brother (turbotrail93) fox coupe will be going in the car, it went 10.9 @ 123 in his fox coupe on 14lbs. I plan on upping the boost to about 20lbs.
Rims are iForged Aeros 18x9/19x11 245/35 tire up front 295/35 out back. Nothing special just some quick iPhone shots..
Anyways on to the pics..
The night my buddy and I were test fitting while drinking a few beers..
Before rolling fenders
After different springs and rolling fenders
A shot of the rims on my terminator
Previous wheel setups on the fox
Current 351w and interior
Vortech 351w going in after I clean it up
I have to swap the front spindles for the center caps to go on the front and swapping a set of disc brakes on the rear along with painting the front this coming up weekend, sorry for all the pics but I hope you enjoy!
Rims are iForged Aeros 18x9/19x11 245/35 tire up front 295/35 out back. Nothing special just some quick iPhone shots..
Anyways on to the pics..
The night my buddy and I were test fitting while drinking a few beers..
Before rolling fenders
After different springs and rolling fenders
A shot of the rims on my terminator
Previous wheel setups on the fox
Current 351w and interior
Vortech 351w going in after I clean it up
I have to swap the front spindles for the center caps to go on the front and swapping a set of disc brakes on the rear along with painting the front this coming up weekend, sorry for all the pics but I hope you enjoy!