2013 gt500 intercooler pump help!!

bfoos59

Member
Established Member
Joined
May 22, 2009
Messages
44
Location
Plattsmouth, NE
Has anyone had the icp relay go bad? I’m intermittently getting a p1229 code, which related to the pump. The wiring looks ok. I believe the only other components are the relay and the pump.

 
Last edited by a moderator:

LS WUT

Well-Known Member
Established Member
Joined
Jun 26, 2013
Messages
4,045
Location
Sarasota, Florida
Has anyone had the icp relay go bad? I’m intermittently getting a p1229 code, which related to the pump. The wiring looks ok. I believe the only other components are the relay and the pump.
Replaced 3 ICP’s on mine, then my harness went bad, then plug was burnt up.
 

Attachments

  • IMG_5299.jpeg
    IMG_5299.jpeg
    273.4 KB · Views: 48

Vinnie_B

"LIVE LIFE AT FULL THROTTLE"
Established Member
Premium Member
Joined
Jun 22, 2021
Messages
1,967
Location
Michigan
Has anyone had the icp relay go bad? I’m intermittently getting a p1229 code, which related to the pump. The wiring looks ok. I believe the only other components are the relay and the pump.

The DTC sets when the PCM commands the supercharger CAC pump to operate but no current is detected.

Check the following:
  • CAC pump motor circuit open
  • CAC pump relay coil open
  • CAC pump circuit open between the relay and the CAC pump
  • CAC pump motor short
  • PCM circuit open between the relay and the PCM
  • Incorrect CAC pump ground connection

**Check for voltage at the relay connector and check the ground connection of the CAC pump motor.



(CAC) Pump Connector​



imagen2.dll



Pin​
Circuit​
1GND (Ground)
4PUMPPWR (Pump Power)

(CAC) Relay Connector


imagen2.dll



Pin​
Circuit​
5PUMPPWR (Pump Power)
3B+ (Battery Positive Voltage)
2CAC (Charge Air Cooler)
1VPWR (Vehicle Power)


Powertrain Control Module (PCM) Connector​



Pin​
Circuit​
B51CAC (Charge Air Cooler)

 

Users who are viewing this thread



Top