What size belt will a 3.12 pulley need on a V2 si trim in a 98 2v. Thanks
3.12 pulley belt size
- Thread starter 98 Roush
- Start date
Are you changing pulley sizes or starting from scratch?
113" belt is the stock belt with a 3.6 pulley. According to belt wrap contact law the difference in size should be about a 1/3" difference. If you can find a belt in the 112" range it should work.
If you get a 10% overdrive crank then a 113" belt is the best fit. What I use but I had to get a Thump Racing Tensioner because I kept shredding belts.
If you get a 10% overdrive crank then a 113" belt is the best fit. What I use but I had to get a Thump Racing Tensioner because I kept shredding belts.
I'm starting from scratch Slo984. Hey stanger I'm keep seeing on Web people using 107.3 belts. I not going to run a 10% overdrive pulley yet. So you think a 112 would work? I also have the stock tensioner.
96-99 2 valves have a 3 bolt tensioner. The 3 bolts use a longer belt over the single bolt tensioner 2 valves. I used to run a 107.3 when I had a single bolt tensioner and the 3.12 pulley.
Try to find a 112.5 or 112.3 if you can. I don't know if there are part numbers for those sizes.
Last edited:
Okay makes sense. Ima go to auto zone or napa tomorrow see what they have. Thanks bro
Yeah I heard about that one, I'm definitely Getting that one. Thanks
Just in case they don't have the right size check AC Delco. Gates doesn't have an HD belt in the size I need, but AC Delco does and it's a green HD belt.
Not sure if they make those HD belts for 6 rib pulleys.
They do BUT you won't find them in the 112" length, OP I have a full list of Gates sizes, I run a 112 with mine, it previously had a 113, I didn't like the slack in it!
So 112 it is. Thanks Brutal Metal
Let me get you the part #, I actually got a new Gates 112" off a guy on ebay last month for under $30~ OK it's GATES K061123, that one is 3/4 of an inch shorter than the 113..
Awesome, thanks a lot Brutal Metal
Users who are viewing this thread
