Hello,
I'm in the process of rebuilding a used center section w/ 4.10 gears to swap out into my IRS equipped 98. I would like to eventually put a diff cooler on the car, but the budget doesn't allow it at the moment.
If I tap and put in the AN fittings, will the caps for an fittings "SEAL" it from leaking any oil after it is installed? I would like to have it already done, so I don't have to pull the new diff later on when the budget allows.
I'm in the process of rebuilding a used center section w/ 4.10 gears to swap out into my IRS equipped 98. I would like to eventually put a diff cooler on the car, but the budget doesn't allow it at the moment.
If I tap and put in the AN fittings, will the caps for an fittings "SEAL" it from leaking any oil after it is installed? I would like to have it already done, so I don't have to pull the new diff later on when the budget allows.