I swapped a 1996 Cobra motor into my 89 Coupe. I've just started driving it and have noticed a few issues and thought I'd get some opinions on what the problems could be.
Other than the body, it is a complete 96 Cobra with 52k miles. (Only current mods: Off-road X-Pipe and 4:10 gears)
1) After I drive it a mile or so, the brakes start sticking. First you can hear the back brakes and then the front start.
2) As I try and accelerate in first gear, it bogs down at 4k rpm and sputters. It was doing this in second gear as well but, it stopped after I drove it a while.
Current Engine Codes:
P1131- Lack of H02S11 Switches - Sensor Indicates Lean (See 2195)
P1519- Intake Manifold Runner Contol Stuck Closed (Bank 1) (see P2006)
Other than these two issue, it seems to run well. It idles as it should and seems to stop well.
Any help would be appreciated, after I fix these issues, it will finally be road worthy.
Thanks in advance.
Other than the body, it is a complete 96 Cobra with 52k miles. (Only current mods: Off-road X-Pipe and 4:10 gears)
1) After I drive it a mile or so, the brakes start sticking. First you can hear the back brakes and then the front start.
2) As I try and accelerate in first gear, it bogs down at 4k rpm and sputters. It was doing this in second gear as well but, it stopped after I drove it a while.
Current Engine Codes:
P1131- Lack of H02S11 Switches - Sensor Indicates Lean (See 2195)
P1519- Intake Manifold Runner Contol Stuck Closed (Bank 1) (see P2006)
Other than these two issue, it seems to run well. It idles as it should and seems to stop well.
Any help would be appreciated, after I fix these issues, it will finally be road worthy.
Thanks in advance.
Last edited: