Accufab throttle body and Vortech tune question

[Shake&Bake]

Installed the accufab to my 98 Vortech Cobra, set the throttle position sensor and all is good. However my car was custom tuned using the stock Ford throttle body and wondering if I should get the car retuned for the Accufab? I assume more air is getting into the engine, not to mention the meth injection as well. Not looking to run lean. However the MAF I assume is reading the amount of air and telling the computer to adjust fuel amount...making a retune unnecessary? Thanks in advance.

 

[decipha]

nope, no retune required

from here: http://efidynotuning.com/post.htm

Retuning Required
Retuning is required under any of the following circumstances

MAF sensor changes - all changes must be made in the MAF transfer ONLY
Fuel Injector changes - all changes must be made in the injector parameters ONLY
Fuel Pressure changes - all changes must be made in the injector parameters ONLY
Cylinder Head Replacement - spark table and peak load function must be updated
Camshaft Replacement - idle air control MAY need to be updated
Base Timing changes - Ignition timing (spark table) and injector timing must be updated
Fuel Grade changes, ex: E-85 or 87 Octane - AFR parameter and/or spark table must be updated