adding a set of heads to the combo anything i should know?

[95S/Ccobra]

im getting a set of edelbrock aluminum heads stage 2 ported along with the rest of my mods am i going to need bigger inhectors or anything?? thanks

here is a list of mods on the car

Powerdyne 11 p.s.i. supercharger
BBk 255 lph in-tank fule pump
Paxton adjustable bullet fuel regulator
Ford Motorsport 30 lb. injectors
North American Motorsports by-pass valve
Pro-M 77mm shorty mass-air in fender kit
BBK 70mm throttle body
Ford Motorsport GT-40 tubular intake
Polished GT-40 intake cover
MSD 6-BTM ignition
Taylor Custom Fit plug wires
BBK JET-HOT coated unequal length headers
Bassani "off-road" X-Pipe
Flowmaster Cat Back Exhaust
Fort Motorsport 3.73 Gears
Ford Motorsport aluminum driveshaft
Ford Motorsport driveshaft safety loop
BBK adjustable clutch quadrant
Pro-5.0 short-throw billit shifter
Ford Motorsport 1995 Cobra "R" wheels

 

[Dino S.]

yes so many times over. yes yes yes yes yes yes yes. You probably need 42 lbers if you want to run street gas on a safe every day tune. 11 psi on an opened up 5.0 is a crapload of power.

I ran 30 lb/ers on my otherwise STOCK 5.0 w/ 10 psi and i blew a piston so bad it would make anybody think twice before cheaping out on their fuel system. I'll send you a picture if you want. The fuel system is not the place to cheap out.

 

[95S/Ccobra]

yea cool send me a pic the blower is pushing just about 9 psi not the full 11 i have an fmu now with 30 pound injectors should i go with the 42's with the fmu or ditch the fmu? and what is need to ditch the fmu?? thanks for your help send the pic to [email protected] if you want

 

[95S/Ccobra]

what cam should i get to go with the heads?? and will my intake be good with the heads or should i get it ported ot match the heads thanks for your help

 

[95S/Ccobra]

ttt anyone??

 

[1 BA SVT]

Originally posted by 95S/Ccobra
what cam should i get to go with the heads?? and will my intake be good with the heads or should i get it ported ot match the heads thanks for your help

get comp cams to custom grind one for you. not much more expensive than an off the shelf but definatlely worth it.