AEM Failsafe settings of afr points not saving question

[ghig50]

I installed an aem. Failsafe a few weeks back tested it for a day or so was able to save upper and lower limits. I am just getting back to having time to work on the car again.
Just went in and tried to change the upper and lower limits I can save them but when I go back in to look at them they are where they where before. Am I missing something. I tried with and without the key on same results. Any ideas. Doea the car need. To be running
There is no save button after you make the changes.
My laptop recently updated to Windows 10 from 8.2
Any ideas?

 

[ghig50]

It is working now.
Rather than deleting the post I will put this up in case some one runs into this.
I rebooted my computer to try that . At that point I realized I had the aem data program open.
Not sure if that is what it was but when I rebooted the computer went back into the car plugged in the laptop then opened up aem failsafe channged the uper and lower limits it worked.
I am able to make changes go out andback in and the changes are saving.