ARH Top Rear Header Bolt

[nsf93]

I am installing at set of ARH 1 and 3/4 headers on my cobra. On the passenger side i have all the bolts in and I can get a wrench onto all of them except the top most rear bolt. Does anyone who has done this job have any tips on how to tighten this bolt? Any information would be helpful.

 

[NateDogg]

A buddy of mine just had issues with that as well. He ended up grinding down his wrench to get it in there.

 

[Cabbage]

Yes I did 1 3/4 and used all factory studs but I had to buy and s shape and a u shape wrench set. They made it very much easier. Pm me and I'll send you pictures of them if you want.

 

[nsf93]

PM sent

 

[MG0h3]

I aborted my install before finishing, but I was going to unbolt the trans crossmember to get the engine lower. There was just no room between the bolt and "frame rail"

 

[gtmustang00]

I feel your pain, the back 2 rear top bolts are a royal pain. Used all factory studs.