Okay there may be a few less than 50 bolts/ push pins but not many. The last steps are to pull the back edges away from the car. Driver side almost falls out. Passenger side feels like its still bolted on.
I've watched a ton of videos and referred to this one while doing it because it was short (didn't have any wasted time like showing unscrewing every single bolt, just one of each group):
Yes, the bolts at the bottom and behind the wheel liner are definitely out as well as all others but those two would be the only ones that could hinder pulling the side out.
If I tug on the outside any harder something will break. I can reach up behind past the wheel line but can't get much leverage to push. Best guess where its hanging up is about midway between the wheel well and the head light. on the back edge of the bumper.
I found a thread where some shop broke a member's bumper pulling too hard but no speculation on why (was NOT bolts still in).
Anyone else have one side or the other hang up or have any ideas for getting it free?
I've watched a ton of videos and referred to this one while doing it because it was short (didn't have any wasted time like showing unscrewing every single bolt, just one of each group):
Yes, the bolts at the bottom and behind the wheel liner are definitely out as well as all others but those two would be the only ones that could hinder pulling the side out.
If I tug on the outside any harder something will break. I can reach up behind past the wheel line but can't get much leverage to push. Best guess where its hanging up is about midway between the wheel well and the head light. on the back edge of the bumper.
I found a thread where some shop broke a member's bumper pulling too hard but no speculation on why (was NOT bolts still in).
Anyone else have one side or the other hang up or have any ideas for getting it free?