This is a BennettRacing 331 based off these specs
BENNETT RACING ONLINE ? 800-240-RACE ? #1 ENGINE BUILDER
The 331-347P is a scaled back version of our 348-363P engine for buyers looking for 485+hp, but yet still maintain the strong foundation of parts used in our 348-363P. This engine will accept up to 300hp nitrous.
DART BLOCK
SCAT 4340 FORGED STEEL CRANKSHAFT
SCAT 4340 FORGED STEEL H BEAM ROD
BENNETT DESIGNED PISTON KIT
SPEEDPRO FILE FIT RING SET
CALICO COATED MAIN & ROD BEARINGS
BENNETT CUSTOM HYDRAULIC ROLLER CAMSHAFT
COMP CAMS TIMING CHAIN
SFI APPROVED BALANCER & ARP BOLT
BENNETT MODIFIED HV MELLING OIL PUMP
CANTON or MOROSO OIL PAN KIT
COMETIC HEAD GASKETS
TFS F.A.C CYLINDER HEADS
FORD MOTORSPORT HYDRAULIC ROLLER LIFTERS
5/16 HD PUSHRODS
BENNETT SPEC ROLLER ROCKERS
BENNETT VALVECOVERS
PORTED EDELBROCK PERFORMER RPM INTAKE
TFS R SERIES INTAKE or HOLLEY SYSTEMAX INTAKE(EFI)
MSD PRO BILLET DISTRIBUTOR & PLUG WIRES
PRO SYSTEMS PREPPED HOLLEY CARBURETOR (CARB)
PRO ASSEMBLED
DYNO TESTED & TUNED
I have receipts of $10,226 for the build
The options chose was
-Diamond Pistons 31106
-Scat H Beam 5.40 Rods
-ARP Bolts
-Stage 2 TFS TW heads
-TFS rockers
-System Max EFI intake
-Bennett EFI Vcovers
-ATI balancer
etc etc
The Motor has about 1800 miles on it and has made hour and half trips easy.
Only reason thinking bout selling to go with coyote swap
If you are local. I can take anyone for ride in the car or send videos etc of motor running.
$5800
located in south mississippi
601-818-0300
or
email [email protected]
I have local shop stangracing.com so I can have motor out in a day if needed to be.
