Question here about bias plys. I have a set of 15x10 LMR SVE Drag wheels. Im thinking of switching to a set of bias ply ET Street R's. Size im looking at is 28x11.5-15LT. It will have a meaty sidewall to absorb the hit of a launch from my GT500. Im also thinking of a 28x11.5-15 ET slick. Car weight with me in it will be about 4020 pounds as well. Setup is only for the track and getting to and from the track, no street racing.
What is the lowest tire pressure you think i can run before the tire will slip on the rim? 20 psi seems to be the consensus for the track and my car weight.
Do i need to use a tube? ive heard conflicting information about tube need. Some run tubes, others do not.
I do not have front runners yet. Much as i would like them, an extra $700 for an entry level set is a bit much at the moment. Do any of you race wIth street radials up front and bias slicks in the rear? I know many advise against it, though ive read many race like that too. This would only be to get to the track, race at the track and head home.
All advice and comments welcomed
What is the lowest tire pressure you think i can run before the tire will slip on the rim? 20 psi seems to be the consensus for the track and my car weight.
Do i need to use a tube? ive heard conflicting information about tube need. Some run tubes, others do not.
I do not have front runners yet. Much as i would like them, an extra $700 for an entry level set is a bit much at the moment. Do any of you race wIth street radials up front and bias slicks in the rear? I know many advise against it, though ive read many race like that too. This would only be to get to the track, race at the track and head home.
All advice and comments welcomed