BIG THANKS TO INJECTOR DUDE, JDM AND Stiegemeier DYNO#'S INSIDE

[CHIKIN1]

I just wanted to post up a big thanks to my friends Injector Dude ( Alan Kennedy ) and THE WHOLE JDM TEAM!!! ( see ya soon guys )
I can't leave out Stiegemeier though. Although I don't have very close business relations with them, this couldn't have happened without their superior porting skills!!!

A BIG THANKS TO YOU ALL

2003 Black VERT w/ Chrome 03's and 13k miles
Mods are as follows:

Solid Axle w/3.55's
UPR Shifter with Tri-ax handle
Slotted/Drilled rotors

JDM/Kooks Long tubes
HI FLOW Cats with Magnaflow catback
2.8 upper pulley w/100mm idlers ( 2 of them )
JDM TUNED SCT CHIP ( with the help of Alan Kennedy and Jim@JDM making adjustments )
K&N open filter ( Don't know the name of the company that made the AI kit )
Stiegemeier Ported blower
Accufab TB and plenum

STD #'s were 527 HP @ 5700rpm and 514ft.-lbs @ 4100rpm
SAE #'s were 515 HP @ 5700rpm and 502ft.-lbs @ 4100rpm

A/F ratio was a HIGH 11 to 12.1 throughout the ENTIRE range once we made a few adjustments.

( on a side note, the boost was 14psi, but fell off to 12psi after 5500rpm )

The car intially made 513 SAE on the 93 octane tune, but we had to add some fuel up top b/c we're running out of injector ( injectors are stock as well as the pumps ) and getting a 13.1 A/F ratio above 5500 rpm. The 93 octane tune then fell to 503 SAE with 5% fuel added up top. The race tune ( which really isn't much of a race tune b/c I don't want to lean on the car too hard ) only has 1 or 2* more timing and brought the car back up to 515 SAE.

I don't really know what else to do to the vehicle since its just my pimpin car
A Heat Exchanger and injectors ( if needed ). I really don't want N20 on this car. Anybody have anymore suggestions??

Anyway, thanks again guys!!! YOU TOO SVT PERFORMANCE!!!

 

[CHIKIN1]

Run Conditions:

66* F
29.35in-Hg
Humidity 68%

 

[mj8]

Nice numbers, you have sweet setup for sure. :beer:

 

[myersusaf]

Daaam, that thing must haul balls! what kind of track times do you expect?? :beer:

 

[CHIKIN1]

Daaam, that thing must haul balls! what kind of track times do you expect?? :beer:

Mid to low 7's in the 1/8th. Low 11's in the 1/4. :banana: :rockon:

 

[WDW MKR]

If you don't want to go spray (I thought everyone in N. Alabama had the bottle?) ;-), you could always add a 2-4lb lower. That would definitely require an HE and MAF or MAFXtender. The injectors and BAP are often debated, but would provide a good safety margin. Upgrades to the cooling system would also be a good idea, if you're going to drive it a lot. I have all of my cooling upgrades on the way.