Okay, so i ran my plumbing yesterday for the boost leash exactly as these instructions showed. CO2 line to the CO2 in port on the solenoid (not hooked up yet waiting on my tank), the TO Y ports off the solenoid go to a Y then a single line ran underneath the car to another Y so they can individually go to a fitting on top of each wg. Drilled and tapped another hole on one wg and ran the line back to the map sensor and attached on the gate side. For the map sensor boost side I ran the tubing and connected it on the cold side compressor housing. I started the car and had no boost indication revving it up to 3k-4k on the leash. On the right hand side of the instructions (the blue line with arrows on the bottom half of the wg's) I have those connected just between the wastegates, do those need tee'd and and connected with another port on the compressor housing? This is my first turbo and boost control so I've got a learning curve going on here lol...
Should add I have 3lb springs in each gate and pressure tested my connections and have no leaks.
Should add I have 3lb springs in each gate and pressure tested my connections and have no leaks.
Last edited: