built TT cobra part out

[ferfont1]

I won't start taking the car apart till the turbo kit sells. I will not part out parts from within the sections. The car only has 17k miles on it, these were put on around 12k, so very low mileage. I would really like to sell this stuff local to avoid shipping. Parts located in Houston, TX.

I'll update with pics when available.

THP twin turbonetics 61mm kit (coated/polished) $6000
-turbo kit:tial wastegates,tial bov
-kmember kit: qa1
-front suspension kit: qa1 arms/strange struts
-coil over kit
-sullivan upper/lower and rails (smoothed/polished)
-SCT big air maf

Aeromotive sump tank kit $1500-a1000 eliminator
-pre/post filters
-braided feed/return lines
-aeromotive regulator
-AN fittings

Viper t56 trans setup $2500
-comp clutch kit (1000+whp capable)
-aluminum driveshaft
-pro 5.0 shifter

Built solid rear $2000
-33 spline moser axles
-c clip elims
-ARP 3.5 studs
-3.73 gears
-coilover kit
-strange shocks
-Aluminum girdle
-braced and welded
-Tubular upper/lower trailing arms (solid bushings)
-from a pre 98 so you can tuck a bigger rear wheel/tire combo

Borla stinger exhaust for the SRA $400

 

[8URSRT]

Got any gauges in it to sell also?

 

[Mike@TF]

so what center is in the rear? it just says the axles..i may want the rear but dont want any of the suspension stuff..

 

[ferfont1]

so what center is in the rear? it just says the axles..i may want the rear but dont want any of the suspension stuff..

oops, its an auburn locker

 

[PapaSmurf03]

Interested in the sullivan upper and lower if you decide to part out.

 

[Fast?notyet]

interested in braided lines and fuel pressure regulator latter on if you decide to seperate i know you dont want to know

 

[2v a-ron]

Pm sent.