Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
SVT Shelby GT500
C-clip eliminators
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JB_2010GT500" data-source="post: 15596725" data-attributes="member: 163228"><p>I think Bad Company posted about this a while back. I believe there is a 9" rear end kit from Moser. I have had two sets of Strange c-clip eliminators (31 and 35 spline versions) and have never had any leaks on my car. But I think I'm in the minority considering there have been several posts regarding leaky c-clip eliminators. I'd think just welding on 9" ends is the superior design from a simplicity, strength, and longevity standpoint. I didn't get too deep into my search since I'm not sure if I could get an off-the-shelf bearing set to fit my 35 spline Strange axles but I know that, as of a year ago, Strange did not offer a 9" end conversion. If and when mine start leaking I'll see if there's a way to run 9" ends with my 35 splines. Until then...</p><p></p><p></p><p>Sent from my iPhone using Tapatalk</p></blockquote><p></p>
[QUOTE="JB_2010GT500, post: 15596725, member: 163228"] I think Bad Company posted about this a while back. I believe there is a 9" rear end kit from Moser. I have had two sets of Strange c-clip eliminators (31 and 35 spline versions) and have never had any leaks on my car. But I think I'm in the minority considering there have been several posts regarding leaky c-clip eliminators. I'd think just welding on 9" ends is the superior design from a simplicity, strength, and longevity standpoint. I didn't get too deep into my search since I'm not sure if I could get an off-the-shelf bearing set to fit my 35 spline Strange axles but I know that, as of a year ago, Strange did not offer a 9" end conversion. If and when mine start leaking I'll see if there's a way to run 9" ends with my 35 splines. Until then... Sent from my iPhone using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
SVT Shelby GT500
C-clip eliminators
Top