Hi there, I'm building a 4V motor & got these pistons by mistake by putting a -2 instead of a -4 at the end of the P/N. eff my day... :shrug:
Anyways, ordered the correct set today & now I'm stuck selling these they are:
Diamond
-.020 over 4.6/5.4L 2V pistons
-2V reliefs
-11.5cc dish
-ceramic coated tops
-scuff coated skirts
-tool steel wrist pin upgrade
-stainless file-fit rings
I have $1500 into them so that is what I'm asking for them.
I haven't sold anything on here before, but I've been a member for quite some time soaking up all the knowledge on the site. Great stuff in here! :beer:
I also have a rough bored 03/04 cobra iron block that I can finish bore to match the pistons. I know that wont apply to any of you guys with a lighting but that option is there for anyone that's maybe doing a 2v mustang build.
Also, I'm located in Vancouver B.C. so they'll probably have to be shipped.
Thanks for your time, Nick.
PM me if you have any other questions & I can send you my number.
I'll add some pics once I figure out how to do it on this damn tablet!
Anyways, ordered the correct set today & now I'm stuck selling these they are:
Diamond
-.020 over 4.6/5.4L 2V pistons
-2V reliefs
-11.5cc dish
-ceramic coated tops
-scuff coated skirts
-tool steel wrist pin upgrade
-stainless file-fit rings
I have $1500 into them so that is what I'm asking for them.
I haven't sold anything on here before, but I've been a member for quite some time soaking up all the knowledge on the site. Great stuff in here! :beer:
I also have a rough bored 03/04 cobra iron block that I can finish bore to match the pistons. I know that wont apply to any of you guys with a lighting but that option is there for anyone that's maybe doing a 2v mustang build.
Also, I'm located in Vancouver B.C. so they'll probably have to be shipped.
Thanks for your time, Nick.
PM me if you have any other questions & I can send you my number.
I'll add some pics once I figure out how to do it on this damn tablet!
Last edited:
