Hey guys, I finally ordered some clear corners, I was looking at the stock ones, it looks like you just have to remove that one 7mm bolt and they come out huh? Any tips or anything to look out for?
just remove the bolt and pull...thats it.
However I did have to swap the speednut over from my stockers to the clears as the speednuts on the clear didnt work.
a speed nut is that c clap shaped jobbie that the 7mm bolt screws into
i had to pry the ones off my clears and swap my stockers onto the clears after filing down a little ridge in the plastic...all is well
the ones that came with the clears out of the box simply would not tighten...they were not grabbing any thread
just remove the bolt and pull...thats it.
However I did have to swap the speednut over from my stockers to the clears as the speednuts on the clear didnt work.
not a problem.
when you pull your stockers, look at the "tab" that the speednut is connected to, and look at that same "tab" on your new clears. You will notice that there is a little rib that is on the clears that is not on your stockers. File that rib down and swap the speed nut over and you are golden
Takes maybe 5 minutes and works perfect