Does my MPH seem right???

[Brad00L]

Last night I went to the track for the first time since I broke a halft shaft and added my new upper/lower combo with amazon tune. Since I broke the halfshaft I was a little scared to launch the car too hard. I did how ever get a new best mph. It went a 7.42 @ 97.56 (2.93 upper / 4lb lower ) with a 1.83 60ft just launching at 2500 rpm.

My previous best before the lower pulley / upper change and Amazon tune was 7.30 @ 95.77 with a 1.65 60ft. (With 2.76 upper ONLY)

I was just wondering is mph low for my mods and what should it run in the 1/4 Going 10/8.

 

[stevenscamaross]

What was the density attitude for the night you ran Brad? Get the info here: www.wunderground.com , Go here and click the resource tab and calculate it. www.modulardepot.com

 

[Brad00L]

DA was only 2036

 

[elmo0244]

i would say you were a lil scared. look at the diff. in your 60ft's. i would be scared if i had broke a axle too.

 

[rACeRs]

Originally posted by stevenscamaross
What was the density attitude for the night you ran Brad? Get the info here: www.wunderground.com , Go here and click the resource tab and calculate it. www.modulardepot.com

Is da the same as hpa? I couldnt find the da on that sight. They list the pressure as hpa. Sorry for the hi-jack.

 

[Brad00L]

You got to get the temp,hum, b.pressure,and track elevation. Then go put it in the da calculator .