I'm installing a Black306 dual fpdm setup and fore hat with revised gt pumps. The fore hat comes with a new harness that I've run through the factory gourmet and over the the fpdm. My question is what are the color of the wires for the pumps. I have the wh/rd and dg/ye seperated as described. But what are the other two? I think they are pr/pi and rd/blk but wanna be sure before I cut and solder new harness in. Thanks in advance.
Dual fpdm install help
- Thread starter spitfirep087
- Start date
Check out west coast mustangs website.. They have a complete guide to a dual fpdm conversion.
http://www.westcoastmustangs.com/articles/tech/dual_fpdm/dual_fpdm.html
http://www.westcoastmustangs.com/articles/tech/dual_fpdm/dual_fpdm.html
I used the Westcoast guide to build my own dual FPDM harness. Its a very good guide. I ran new power and ground wires to my pumps and deleted the stock set.
On the hat, you should have 6 wires. Yellow is the gas gauge, black is ground, then you have 2 positive and 2 negitive wires for the pumps. It is important that the positive and negative pairs from the FPDM go to 1 pump. Do not mix match them.
On the hat, you should have 6 wires. Yellow is the gas gauge, black is ground, then you have 2 positive and 2 negitive wires for the pumps. It is important that the positive and negative pairs from the FPDM go to 1 pump. Do not mix match them.
Users who are viewing this thread
