Eaton blower dimensions needed
- Thread starter LT1BIRD
- Start date
Diameter of pulley is going to change your measurement. Also the pulley geometry will change the distance too. Need to measure to center of pulley for an actual height dimension and to a center of a rib for the other dimension. Going to need a straight edge or laser to do what you are asking.
Why do you need these dimensions?
Why do you need these dimensions?
well.... I have a kenne bell right now.. lil 2.1 my setup is a mess.. its in a 66 mustang and I dont have much room in there.. or hood clerance... I am thinking of putting an eaton in there and running a large rear mount turbo..as thats all i really have room for... I might try and do the kenne bell with the compound but I hear is does not like it as the seals leak... so i have a 2001 cobra front accessory drive setup with stubby blower snout.... I am trying to see if the pully on the eaton will clear my hood sticking out that far... yes i get you on the pully size but that dimension would give me a ball park 
What about a Sullivan intake if you ever decide to go turbo? Depending on how much hood clearance you have.
I looked at that but I really dont have room for an intercooler anyplace else other than under the intake... I was thinking of just making a simple adapter and mounting the throttle body to it... keep that intercooler... but the blower seems to be a better fit for me at this time...
I think Procharger used to make a hat that bolted to the lower intake. If you do your own adapter you could get all kinds of funky.
I think with the intercooler in there the air would get smoothed out and would not be an issue..... at least at my power lever lol... but yes, I have looked at that hat... not sure they sell it seprate...
Users who are viewing this thread
