OK, this Q is about the rear needle bearings in the Eaton case, nothing to do with the snout. I have my Eaton apart right now polishing it. Looking for some advice or past experiences.
How difficult is it to pull out the bearings from the case without destroying them?
If they get damaged, can you get new bearings from Ford or where is the best place?
I have seen that Mobil 1 synthetic grease mentioned as the correct product to use, is that correct.
Thanks all.
How difficult is it to pull out the bearings from the case without destroying them?
If they get damaged, can you get new bearings from Ford or where is the best place?
I have seen that Mobil 1 synthetic grease mentioned as the correct product to use, is that correct.
Thanks all.