Edelbrock Vic jr Plumbing

[Lou02stang]

Take a look at my setup and see if it's all correct. I ran all 8an lines and also did the Head Cooling Mod. Can I just cap the Fuel Pressure sensor or do I have to run a hose back to the other rail?




http://s1067.photobucket.com/user/Lo... Jr Intake

 

[StrayBullitt]

Can't seem to open your picture, but I am using the fuel pressure sensor with an adapter on my Vic Jr. setup and both rails are joined at the front with a crossover hose.

 

[Lou02stang]

Sorry

fixed the link now

http://s1067.photobucket.com/user/Lou94Stang/slideshow/Edelbrock Vic Jr Intake

 

[StrayBullitt]

That looks killer and should work out good. Yes you should install a plug at the back of the rail behind the sensor. My sensor is at the front of the rail on my setup (mmr rails/kit) but, works exactly the same.

 

[Lou02stang]

Thanks. Where did you install your IAT sensor. Is it in the manifold or in the plenum

Just powder coated the 6061 plenum and Accufab Throttle Body in the black pearl also.

 

[StrayBullitt]

Lou, I am still running the intake air temp sensor in the intake pipe just as factory.