Hello All,
I'm looking for some clarification on electronic boost controllers.
I'm in the process of finalizing a single turbo install, and want to have the ability to more precisely control the boost.
A few questions:
1. Can I run a very small spring in the waste gate and then use the boost controller to command a higher psi.
For example, lets say I have a 4lb spring, and command a 10 psi boost. The intent is to have the latitude to to change settings anywhere within that window.
2. If the above is possible, which I suspect it is based upon what I know of boost controllers, are there any negative implications of the above?
I'm looking for some clarification on electronic boost controllers.
I'm in the process of finalizing a single turbo install, and want to have the ability to more precisely control the boost.
A few questions:
1. Can I run a very small spring in the waste gate and then use the boost controller to command a higher psi.
For example, lets say I have a 4lb spring, and command a 10 psi boost. The intent is to have the latitude to to change settings anywhere within that window.
2. If the above is possible, which I suspect it is based upon what I know of boost controllers, are there any negative implications of the above?
