Well Santa sleigh got a bit delayed but should be here early next week.
Here is a list of what I got so far:
CP/ModMax Flattops ~10.75 compression
h13 tool steel .200
SS rings
Manley H-beam w/arp2000
arp mainstud kit
Going to order coated clevite main and rod bearings next week and that should finish up the bottom end.
The plan for the top end is pretty much stock for now. the head are at the machine shop getting new seal seat and a valve job.
what is needed to degree the cams ?
4 adjustable secondary gears and 4 keys ? any thing else ?
As far as Valve reliefs are concerned. how deep and both intake and exhaust ? How much will it lower compression ?
Goals are Turbos down the line. Staying with stock cams for now. and pump gas. Eventually going E-85 .
Here is a list of what I got so far:
CP/ModMax Flattops ~10.75 compression
h13 tool steel .200
SS rings
Manley H-beam w/arp2000
arp mainstud kit
Going to order coated clevite main and rod bearings next week and that should finish up the bottom end.
The plan for the top end is pretty much stock for now. the head are at the machine shop getting new seal seat and a valve job.
what is needed to degree the cams ?
4 adjustable secondary gears and 4 keys ? any thing else ?
As far as Valve reliefs are concerned. how deep and both intake and exhaust ? How much will it lower compression ?
Goals are Turbos down the line. Staying with stock cams for now. and pump gas. Eventually going E-85 .