Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Lightning Forums
2nd Generation
engine rebuild crank shaft spacers?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="lightning ride" data-source="post: 302723" data-attributes="member: 7810"><p>AUYON,</p><p></p><p>If you have your engine bolted to an engine stand, be careful when you remove the rear main bearing. These bearings that I asked about like to drop out. I know from experience. If I new they were their I would of marked them and make it easier for the rebuild. Also, the rear seal cover and seals be careful with. The Ford dealer could not tell me if this can with the gasket sets.</p><p></p><p>TWISTED99</p><p></p><p>I fluxed the block and had to buy a new one.</p><p></p><p>LIGHTNING LARRY</p><p></p><p>I know Manley makes a nice rod and they are going in the motor along with many other things.</p><p></p><p>Any one that actually has rebuilt one of these motors and installed these side mounted bearings please let us know what you found. Manuals are good but experience is better.</p></blockquote><p></p>
[QUOTE="lightning ride, post: 302723, member: 7810"] AUYON, If you have your engine bolted to an engine stand, be careful when you remove the rear main bearing. These bearings that I asked about like to drop out. I know from experience. If I new they were their I would of marked them and make it easier for the rebuild. Also, the rear seal cover and seals be careful with. The Ford dealer could not tell me if this can with the gasket sets. TWISTED99 I fluxed the block and had to buy a new one. LIGHTNING LARRY I know Manley makes a nice rod and they are going in the motor along with many other things. Any one that actually has rebuilt one of these motors and installed these side mounted bearings please let us know what you found. Manuals are good but experience is better. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Lightning Forums
2nd Generation
engine rebuild crank shaft spacers?
Top