Clearing the garage out. Found a box of parts I'm never going to use from a dead project. Was going to run an M112 on my 3.8 sixer, but then scored a deal on the appropriate ProCharger for my car.
As such I have:
- BBK CAI upper pipe with couplers and clamps
- Two CAI elbows, one is stepped to accept a 90mm MAF
- 90mm MAF - unknown manufacturer
- CAI fender plate
- Blower pulley - pretty sure it's stock ratio
- Dual plate throttle body with intake elbow - No TPS attached
Most of the chrome parts have blemishes (light scratching or pitting) - no deep gouges. Should clean up with some elbow grease and polish or 0000 wool.
Would prefer to sell everything in one shot.
$175 takes the whole box shipped to your door.
Located in North Jersey if you're a local and want to pick-up.
_
As such I have:
- BBK CAI upper pipe with couplers and clamps
- Two CAI elbows, one is stepped to accept a 90mm MAF
- 90mm MAF - unknown manufacturer
- CAI fender plate
- Blower pulley - pretty sure it's stock ratio
- Dual plate throttle body with intake elbow - No TPS attached
Most of the chrome parts have blemishes (light scratching or pitting) - no deep gouges. Should clean up with some elbow grease and polish or 0000 wool.
Would prefer to sell everything in one shot.
$175 takes the whole box shipped to your door.
Located in North Jersey if you're a local and want to pick-up.
_