Does anyone know or have a pic or the PN of the plastic rivets needed to mount the bumper cover to the bumper support? They are the ones that go through the four plastic tabs to the metal support. Thanks
Front bumper cover rivets?
- Thread starter LightningLou
- Start date
I just put a new front bumper cover on, had to remove the old rivets from the metal support, put the new ones in and install. Bought it from LMR. Mustang Front Bumper Cover Hardware Kit (94-04) - LMR
Thanks, but that is not what I’m looking for. I’m talking about the large 10mm dia or so rivets that go through the 4 plastic tabs on the bumper cover to the metal support.
Is it not possible to go with a nut & bolt setup versus the original rivets?
I'm trying to picture where exactly on the back-side of the bumper to the metal frame you're referring to...
I'm trying to picture where exactly on the back-side of the bumper to the metal frame you're referring to...
I stand corrected sirs. For some reason I thought they were some kind of big plastics rivets there which is what was on the truck when I removed it, but they didn’t seem correct by the somewhat looser fitment. I saw an install diagram and it is just basic hardware to install the L bumper covers. I can always grab some decent hardware at Ace, but that seems like such a pain to remove and install if needed because the location sucks. Wish someone made some quick disconnect fasteners or aftermarket rivets for our trucks... Oh well
Users who are viewing this thread
