This is a non teksid shortlock that I built and has 12,000 on the rebuild. It is bored .20 over and the crank is ground .10 under. It has Manley connecting rods, Manley pistons, cobra crank, and ARP main bolts. The problem is ever since first day I started the engine, it had one cylinder with bad piston slap. I ran it like this for 12,000 miles and ran fine when I took it out other then burning some oil and the piston slap. I finally took it out this fall and found the left rear drivers piston a lot of play and was make a mark in the cylinder. The other cylinders didn't look too bad. The cylinders are starting to get some rust in them too. If the short block doesn't sell I will sell the crank, rods, and bolts. Looking to get $550.
Rods and studs sold!
Cobra crank for sale yet. $120
Rods and studs sold!
Cobra crank for sale yet. $120
Last edited:
