FS: TF Polished Mach 5s (18X9 & 19X10)

TTOPCPE

Member
Established Member
Joined
Jul 14, 2009
Messages
161
Location
Springfield, VA
Selling my TF two piece polished mach 5s. The fronts are 18X9 and the rears are 19X10. Fronts are big brake cut and the rears are the sleeper offset for SRA, however I ran them on my IRS without a spacer and liked them.
The tires are Hankook Ventus V12 EVOs. Front are 265ZR 35 18 and rear are 295ZR 30 19.
The tires have less than 200 miles on them. The wheels were never in the rain. These are basically brand new and were on a garaged kept car. Only reason for selling them is I sold the car.
The wheels/tires are located in my dad's garage in Northeast PA. I could bring them down to Northern VA if necessary.
$2,800

TFonCobra_zps9b73ef1d.jpg

TFonCobrafront_zpsc3c7a27c.jpg

TFonCobrarear_zps2f0fbe1f.jpg

2004-01-010021_zps5204cbb2.jpg
 
Last edited:

TTOPCPE

Member
Established Member
Joined
Jul 14, 2009
Messages
161
Location
Springfield, VA
A few have asked if I'd do trades...
About the only thing I'm looking for currently would be..
A MM K Member for a 99-04 2V car
Or an On3 FF turbo kit, a kenne bell or Saleen Series IV blower
 

TTOPCPE

Member
Established Member
Joined
Jul 14, 2009
Messages
161
Location
Springfield, VA
Blower purchased. Would also consider trades for 2V exhaust such as Bassani Mids and matching catted X pipe of MAC long tubes and matching prochamber. Would also be interested in Magnaflow magnapack catback or Borla catback etc.
 

Chris0304

Well-Known Member
Established Member
Joined
Feb 20, 2010
Messages
737
Location
Virginia
I wish these were 18's. I'm not sure about the 19's on the rear. It doesn't leave enough room for rubber!
 

Users who are viewing this thread



Top