Getting some parts installed this week...any maintenance items I should have done..?

[K-Dubb]

I am having the following parts installed this week:

H&R Race Springs
M&M Full length Subframe connectors
UPR Catted X
17x10.5s with 315 Mickey Ts
3/8" Lethal Hubcentric spacers
IRS Brace


Is there anything I need to do while these are getting installed? Any bolts need to be re-torqued that normally come lose or anything like that? I was thinking there was a bolt that needed to be torqued to 250 ftlbs that normally becomes lose, but I can't remember what it was!

Thanks.

 

[SVT03Chris]

Are you having a shop put them on? (I assume you are since you said "while I wait")

I would just go over all their work and make sure everything is tight and looks right.

 

[fiveoh2go]

Might as well throw on a new fuel filter while they're installing the IRS brace.

 

[K-Dubb]

Are you having a shop put them on? (I assume you are since you said "while I wait")

I would just go over all their work and make sure everything is tight and looks right.

Yes I am.

Might as well throw on a new fuel filter while they're installing the IRS brace.

I figured someone would say that, thanks.

 

[Ralo]

You can prob do all of that yourself and then have the subframes welded up. You also might not need those spacers,

 

[xfrosty63x]

The cats that UPR uses are garbage.