Got a few things done this week

[SVTJAY]

Installed Metco Idlers

Extrude honed and polished upper & Billet flow TB

Phenolic Spacer

 

[SVTJAY]

This weekends project

FTVB 4C and the Moroso Pan

 

[SID297]

How do you like the tranny pan? It's the one I'm going to buy.

 

[SVTJAY]

I think its the best pan out there, Its not cast its welded, extremely lightweight, 4 1/2 quarts extra capacity, and doesn't hang as low as the 4x4 pan does, and the drain plug is on the side not the bottom

 

[SID297]

The worksmanship (is that a word) looks great.

 

[crazy4ink]

That Moroso pan looks quality man! Where did you order it from and if you don't mind me asking, what did you pay for it?

 

[SID297]

They're $160 from both Jegs and Summit.

 

[crazy4ink]

Cool SID, thanks!

 

[SVTJAY]

A couple of the completed pics. You can see the pan really doesn't hang but about 1/4 inch lower then the frame cross member.

 

[boostdacr]

will the FTVB and panel void the warranty?

 

[TXRickC]

didn't Metco change the design of this a few months ago?

 

[SID297]

I like that tranny pan.

 

[SVTJAY]

Originally posted by TXSVTLIGHTNING
didn't Metco change the design of this a few months ago?

yes i have had this one laying around for quite some time.

 

[latemodelracer2]

I have a bunch of parts lying around here that ive been needing to get around to installing. (fluidyne heat exchanger, FTVB, 4x4 pan and filter, 58" bars, JLP cold air/ram air, diablo helion scan tool, 75 hp nitrous jets)

 

[SVTJAY]

Yeah im going to be doing the Brisk plugs tomorrow. And a ported blower next week

 

[SID297]

Do the plugs when you have the blower off, it's much easier.

 

[latemodelracer2]

Originally posted by SID297
Do the plugs when you have the blower off, it's much easier.

Ditto

cuts the time in half fo the plug change and makes it 10 times easier