GT500 5.4 Aluminum Engine Complete LONG BLOCK

N

nycmikie1

Member
Established Member
Joined
Mar 31, 2012
Messages
57
Location
NY
Ford GT Aluminum Short Block

Aluminum Ford GT wet block .010 over
ARP Main studs.ARP side bolts
New SVT oil pump 13/14
New MMR Manley flat top piston,tool steel pins and fitted.
New ARP 2000 rod bolts
New bearings and rings,rear main seal
honed with Torque plate.
Cali coat all bearings along with piston skirts.
Mag crank and rods new condition. Not ran since redone
SHORT BLOCK $7500
 
Last edited:
5

5.4 notch

Member
Established Member
Joined
Dec 28, 2008
Messages
231
Location
nh
Who built the motor...where all the parts new...and would u sell just the short block. Thanks
 
N

nycmikie1

Member
Established Member
Joined
Mar 31, 2012
Messages
57
Location
NY
About my heads

Thanks but rather sell a complete Engine.
This leaves me with parting out piece by piece and that's not for me .
 
Last edited:
N

nycmikie1

Member
Established Member
Joined
Mar 31, 2012
Messages
57
Location
NY
very complicated to explain Notch. You would have to know me and how I built my vehicles.
Engine was never hurt other then I had to put in a new set of pistons.I had the short with ported heads,Ford GT cams and a TVS blower installed in my 08 GT500 4000 pound street car ran a best of 9.49@143 mph.
my stuff has very little run time was in my car 2 years before getting freshened.I did maybe 300 street miles and 5 or 6 outings to a Rental.
If your serious the short will cost you $8000 and is complete with no expense spared,built by me.I have all specs.This was not built for resale but for myself, I am selling it cause the Ford GT is a better resale then a cast block as people put $6k into a 2011 aluminum bare block with sleeves and still not equal to a Ford GT
I have another big project going on so this is why the sale.
youtube tvs+pumpgas=9s
Its a Red 500 with black stripes
 
Last edited:
N

nycmikie1

Member
Established Member
Joined
Mar 31, 2012
Messages
57
Location
NY
This block has factory sleeves and at .010 over there was not need to Change any sleeves.
You can go up to .030 before changing factory sleeves.
 
N

nycmikie1

Member
Established Member
Joined
Mar 31, 2012
Messages
57
Location
NY
The short is $8000 firm
Comes with arp head studs,svt oil pump,svt head gasket,2013,14 aluminum oil pan.
Power wise i am sure 1200 hp would not be a issue....
You know no matter what its all in the tune.
Serious this was not built for resale so it's a real good piece and the best block money can buy for our 500s. I have many big projects and decided to sell my short since it will sell fastest.
 
Last edited:

Users who are viewing this thread

Total: 2 (members: 0, guests: 2)


Top