Guess My Numbers!

Jarrett H

New Member
Established Member
Joined
Jun 2, 2007
Messages
162
Location
Iowa
Going to get my truck tuned by Kurgan Motorsports Monday on 93 pump.

Built engine, patriot stage 2 heads, Crower turbo cams, sctba2400/mafia, 76gts turbo/.96 AR, 3 1/2 exhaust no cats, sct chip, stock intercooler, electric fans, dual Walbros, 60lb injectors, and a few other parts that make it more reliable. Stock stall by the way, but I have a valve body.

It put down 550rwhp/650rwtq at 15psi before being built, heads, and cams.

Going to try and get at least 18psi on 93 pump. The temp in the dyno room will probably be below 60 degrees.
 

Jarrett H

New Member
Established Member
Joined
Jun 2, 2007
Messages
162
Location
Iowa
I would be really happy if I hit 700rwhp. I have seen 2.6 and 3.4 whipple and kb trucks do 650rwhp with similar mods. I should be able to make a little more power. This is going to just be a pump tune. In the spring, I'll go back and get a C-16 tune with more boost. It is a custom kit built by Jeff McCool. Stainless piping to a 76gts using the stock IC.
 

04cobradude

Mack Daddy
Established Member
Joined
Jul 28, 2005
Messages
901
Location
Gainesville, GA
the dyno we use is VERY conservative... my car reads 80rwhp less on this dyno then on other dynos in the area.. If we make 650rwhp on pump through that big ass heavy transmission, driveshaft, and rear end, i would be super happy!!

Cya on monday afternoon!
 

Users who are viewing this thread



Top