Heat Exchanger......will i need a tune?

[dirtyjerz5.0]

mods are as follows

H&R Race Springs
Maximum Motorsports Caster/Camber Plates
Maximum Motorsports Full Length Subframe Connectors
Fiore Firewall Adjuster and Quadrant
Power Stack Open Element Cold Air Intake
Borla Stinger Cat Back
2.76" Billetflow Pulley with 100mm Idler (Black)
Tuned by Bob Kurgan: 452hp and 474tq

Now if i decide to throw on a heat exchanger, will i need to retune it?

i was also thinking of doing a midpipe as well down the line

 

[mu22stang]

Aftermarket heat exchanger...no
Aftermarket midpipe...yes, it's a good idea

 

[MVD]

Now if i decide to throw on a heat exchanger, will i need to retune it?

:lol::lol::lol:

 

[01SVTSTANG]

:lol::lol::lol:

He didn't know which is why he asked. Don't be a dick oke:

 

[SpectorV]

you will have no issues, I personally did nothing but a heat exchanger (afco dual pass) after a dyno session, went back and it was still perfectly fine next dyno. This is a GREAT opportunity to replace the heat exchanger electric pump as they go dead after a few years and slow down. While the coolant is drained swap it in

Feel free to PM me about how to's on installing I will be happy to help, the only issue I personally had was AIR in the system... took a bit to get it out so it would circulate.

 

[unit213]

Now if i decide to throw on a heat exchanger, will i need to retune it?

Definitely not.

i was also thinking of doing a midpipe as well down the line

Anytime you change the airflow into our out of your engine, it's a safe bet to check your A/F ratio.