So I am an idiot and was running a belt that was a half inch short, I didn't read the paragraph and chart thoroughly where it says add a half inch for billetflow bracket and snub idler.
Anyways I was trying to get the belt on, since I had it on once I figured it was fine and I could get it on again.
I ended up putting too much pressure on the stock tensioner and arm and it snapped off. Looks cheap, like pot metal or something.
I'm having difficulty locating a new replacement one from the dealer.
Anyone have any suggestions?
There is the tensioner arm with the pulley on the end of it, but there is a bracket that it bolts onto which goes all the way across the front, the parts guy at the dealer mentioned 600$
No way. I'll buy nitrous and aftermarket stuff before I pay $600 for a tensioner pulley and bracket!
Thanks in advance
Joe
Anyways I was trying to get the belt on, since I had it on once I figured it was fine and I could get it on again.
I ended up putting too much pressure on the stock tensioner and arm and it snapped off. Looks cheap, like pot metal or something.
I'm having difficulty locating a new replacement one from the dealer.
Anyone have any suggestions?
There is the tensioner arm with the pulley on the end of it, but there is a bracket that it bolts onto which goes all the way across the front, the parts guy at the dealer mentioned 600$
No way. I'll buy nitrous and aftermarket stuff before I pay $600 for a tensioner pulley and bracket!
Thanks in advance
Joe