I have a 3 bar map sensor and was wondeirng what plug you use to plug into it. I know you hook vacume up to it but was wondering about the plug.
Hooking up your map sensor
- Thread starter Mr.GSXR1000
- Start date
Need some info, i know out of all these turbo cars someone has info. Everyone should have one
It will need to be rewired to your car with the plug that came with it.
What brand are you using? AEM, or a GM 3 bar?
I honestly dont know many people that bother with them on the Cobras.
What brand are you using? AEM, or a GM 3 bar?
I honestly dont know many people that bother with them on the Cobras.
GM 3 bar is the one im using. Where do i rewire it to? Thats the part im having trouble with. So people dont have to run them?
No we dont usually run them, or at least what I seen. The factory one reads up to 1 bar or 14.7psi.
The Cobra has a Map-sensor and a Temp sensor in the same sensor. So you map reads boost pressure as well as secondary air temps. So if you do add a 3 bar map sensor and would like the secondary temp you would have to figure that one out yourself lol.
Any event, the map sensor is on the drivers side on the bottom base of the blower near the fire wall.
If you have a turbo setup or the blower was removed them its custom installed where ever the installer put it, if they even put it on.
Users who are viewing this thread
